How to Factory Reset a LeEco Security Camera16

Over time, your LeEco security camera may encounter minor issues that can be resolved by performing a factory reset. This process will restore the camera to its default settings, erasing all user-defined configurations and saved data.

Steps to Factory Reset a LeEco Security Camera:
Power on the Camera: Ensure your LeEco security camera is connected to a power source and turned on.
Locate the Reset Button: Most LeEco security cameras have a reset button located either on the bottom or back of the device. Refer to your camera's user manual if you cannot find the reset button.
Press and Hold the Reset Button: Press and hold the reset button for approximately 10-15 seconds or until the camera's status light starts blinking. Release the button once the light starts blinking.
Wait for the Reset to Complete: The factory reset process typically takes a few minutes to complete. During this time, the status light will continue to blink.
Confirm the Reset: Once the status light stops blinking, the factory reset is complete. You can now reconfigure your camera from scratch.

Additional Notes:

Here are some additional points to consider when performing a factory reset on your LeEco security camera:
Data Loss: The factory reset process will erase all user-defined settings, saved recordings, and any other data stored on the camera. It is important to back up any critical data before proceeding with the reset.
Re-Authentication: After a factory reset, you will need to re-authenticate the camera with your LeEco account. This is necessary to regain access to the camera and its features.
Troubleshooting: If you encounter any issues during the factory reset process, consult your camera's user manual or contact LeEco technical support for assistance.

2024-11-12

Previous：DIY Home Security Camera System Tutorial

Next：Where to Place Surveillance Equipment in Ma‘anshan