New BMW 3 Series Parking Surveillance Setup49

Congratulations on your new BMW 3 Series! This high-performance vehicle comes equipped with a variety of advanced features, including a state-of-the-art parking surveillance system. This system can help you to park your car safely and easily, even in tight spaces. In this article, we will walk you through the steps on how to set up your BMW 3 Series parking surveillance system.

Step 1: Gather Your Materials

Before you begin, you will need to gather the following materials:
Your BMW 3 Series owner's manual
A Phillips head screwdriver
A Torx T25 screwdriver
A 10mm socket wrench
A pair of needle-nose pliers

Step 2: Prepare Your Car

Once you have gathered your materials, you will need to prepare your car for the installation. To do this, park your car on a level surface and turn off the engine.

Step 3: Remove the Rear Bumper

The next step is to remove the rear bumper. To do this, follow these steps:1. Open the trunk and remove the two bolts that secure the trunk lid to the bumper.
2. Use a Phillips head screwdriver to remove the four screws that secure the bumper to the rear of the car.
3. Use a Torx T25 screwdriver to remove the two screws that secure the bumper to the wheel wells.
4. Carefully pull the bumper away from the car.

Step 4: Install the Parking Sensors

Once the rear bumper has been removed, you can install the parking sensors. To do this, follow these steps:1. Identify the locations of the parking sensors on the rear bumper.
2. Drill a 22mm hole in each location.
3. Insert the parking sensors into the holes and tighten them into place.
4. Connect the parking sensors to the wiring harness.

Step 5: Reinstall the Rear Bumper

Once the parking sensors have been installed, you can reinstall the rear bumper. To do this, follow these steps in reverse order of the steps in Step 3.

Step 6: Setup the Parking Surveillance System

Once the rear bumper has been reinstalled, you can setup the parking surveillance system. To do this, follow these steps:1. Turn on the ignition.
2. Press the "Menu" button on the iDrive controller.
3. Select "Settings."
4. Select "Parking."
5. Select "Parking Surveillance."
6. Select "On."

Step 7: Test the Parking Surveillance System

Once the parking surveillance system has been turned on, you can test it by reversing your car close to a wall or other object. The parking sensors will emit a series of beeps as you get closer to the object. The beeps will become more frequent as you get closer to the object. When you are about to hit the object, the beeps will become a continuous tone.

Conclusion

Congratulations! You have now successfully set up your BMW 3 Series parking surveillance system. This system will help you to park your car safely and easily, even in tight spaces. We hope this article has been helpful. If you have any questions, please consult your BMW 3 Series owner's manual or contact your local BMW dealer.

2024-11-09

Previous：A Comprehensive Guide to Video Doorbell Monitoring

Next：Hannam District Surveillance Equipment Configuration Center