How to Configure IP for Hikvision Camera326

Introduction
Hikvision, a leading manufacturer of security surveillance equipment, offers a wide range of cameras to meet the diverse needs of their customers. In order to effectively utilize these cameras, it is essential to understand how to configure their IP addresses, which allow for remote access and control over the camera system.
Prerequisites
Before beginning the IP configuration process, ensure that you have the following:
* Hikvision camera
* Ethernet cable
* Router or switch
* Web browser
Steps to Configure IP
1. Connect the Camera: Physically connect the Hikvision camera to your router or switch using an Ethernet cable.
2. Power on the Camera: Power on the camera and allow it to boot up.
3. Access the Web Interface: Open a web browser and type the camera's default IP address into the address bar. The default IP address for Hikvision cameras is 192.168.1.64. If you have modified the IP address previously, use the modified address instead.
4. Login to the Camera: Enter the default username and password for Hikvision cameras, which are "admin" and "12345" respectively.
5. Navigate to IP Configuration: Once logged in, navigate to the "Network" tab and select the "Basic Settings" option.
6. Configure IP Address: In the "IP Configuration" tab, select the "Obtain an IP address automatically" option. This will assign a valid IP address to the camera from the DHCP server on your network. If you prefer to assign a static IP address, select the "Use the following IP address" option and manually enter the desired IP address, subnet mask, and gateway information.
7. Save Changes: Once you have configured the IP address, click the "Apply" button to save the changes.
8. Verify IP Address: To verify that the IP address has been successfully configured, go to the "Device Information" page and check the "IP Address" field.
Troubleshooting Tips
If you encounter any issues during the IP configuration process, try the following troubleshooting tips:
* Ensure that the Ethernet cable is securely connected at both ends.
* Verify that the camera is receiving power and is properly booted.
* Reset the camera to its factory default settings. To do this, press and hold the "Reset" button on the camera for more than 10 seconds.
* Contact Hikvision technical support for assistance.
Conclusion
Configuring the IP address of a Hikvision camera is a straightforward process that enables remote access and control over the camera system. By following the steps outlined above, you can ensure that your Hikvision camera is properly configured and ready to use.

2025-02-10

---

Previous：256GB SD Card Monitoring with Hikvision

Next：How to Configure Hikvision Surveillance Video