Hikvision Camera Power Supply Replacement Guide369

Replacing the power supply for a Hikvision surveillance camera is a relatively simple process that can be completed in a few minutes. Follow these steps to safely and correctly replace the power supply:

Safety Precautions

Before beginning any work, ensure that the camera is powered off and disconnected from the power source. Failure to do so could result in electric shock or other injuries.

Identify the Power Supply

Locate the power supply for the camera. It is typically a small, black box that is connected to the camera via a cable. The power supply may be located inside or outside the camera housing.

Disconnect the Power Supply

Disconnect the power supply from the camera by unplugging the cable. If the power supply is located inside the camera housing, you may need to remove the housing to access the power supply.

Remove the Old Power Supply

Once the power supply is disconnected, remove it from the camera. There may be screws or clips that need to be removed to release the power supply.

Install the New Power Supply

Align the new power supply with the mounting bracket on the camera. Secure the power supply with screws or clips.

Connect the Power Supply

Plug the power supply cable into the camera. If the power supply is located inside the camera housing, you may need to reassemble the housing.

Power On the Camera

Power on the camera and verify that it is functioning properly. The camera should power up and begin transmitting video.

Troubleshooting

If the camera does not power on after replacing the power supply, there may be a problem with the new power supply or the camera itself. Try the following troubleshooting steps:
Verify that the new power supply is providing the correct voltage and amperage for the camera.
Check the power supply cable for any damage.
Try connecting the camera to a different power source.
If the camera still does not power on, the camera itself may be defective and may need to be replaced.

Conclusion

Replacing the power supply for a Hikvision surveillance camera is a simple process that can be completed in a few minutes. By following these steps, you can ensure that your camera is receiving the correct power and is functioning properly.

2024-12-14

Previous：Wireless Surveillance Recommendations

Next：Hikvision Camera Frame Rate Settings